Apple iPhone is not recognized in iTunes Windows

June 28, 2008 | By admin In iPhone drivers |

When you connect your iPhone to the PC and it will not list in the source list, you have a problem. If you experience this kind of problem, make sure you check the followings:

  1. Check the battery. When you connect your iPhone to the PC and it says” Charging… please wait” , it means that you are low in battery. Just wait until it has sufficient power to connect to your PC.
  2. Make sure that your PC requirement is met. Refer to the manual for PC minimum specification.
  3. Ensure that your PC drivers especially graphics and audio are updated. Refer to the manufactures of your graphics and audio cards website for updated drivers.
  4. Check your USB connections. If you have more than 1 USB port, try to connect to different USB port.
  5. Verify iPhone driver/service installation. USBAAPL.SYS is used as iPhone driver. This USBAAPL.SYS is automatically installed when you install iTunes. If they are not installed, try to reinstall your iTunes. Download the latest iTunes here. If re-installing latest iTunes does not solve the problem with USBAAPL.SYS, try download USBAAPL.SYS directly.

For more details, you can take a look at apple iphone support site.

Other Related Posts:

5 Comments so far

  1. Another tips for Apple iPhone not Recognize by PC | iPhone troubleshooting | Download Apple iPhone Drivers on July 10th, 2008

    […] your iPhone is not recognize in iTunes, you could try the […]

  2. Do you really need to download iPhones driver? | iPhone drivers | Download Apple iPhone Drivers on July 20th, 2008

    […] Hope this could help you solve the problem. Otherwise, try looking other article on iPhones is not recognize by iTunes. […]

  3. niherasebekei on September 3rd, 2008

    Beautiful design.
    Thanks, webmaster.

  4. Leighton on December 30th, 2008

    Hi!

    FANTASTIC!!!! been sitting here with my new iphone for about 3 hours trying to get it to work - you fixed it!!!!!!

  5. Tony Nassar on February 18th, 2009

    i’ve install the itunes 8.0 it ask me to upgrade my iphone 2g to 2.2.1 firmware, by using windows vista the mission was completed & it was installed successfully, then i tried to install cydia by using quickpwn 2.2 but it stop responding & closed by windows, here my iphone was not recognised by my computer any more,
    now i try to put it in dfu mode or restore mode, the quickpwn close with not responding while the itune start installing the firmware into the iphone till 15 minutes i c an error 1601 or 1604 & some times 2002

Leave a reply